DC-17 Realistic Version with Holster | Moving Trigger | DIY Kit
The files are based on Galactic Armorys DC-17 but the kit has been simplified for a clean print and easy build.
There is space for electronics and the upper body is held on by magnets for easy access.
You will need the following hardware.
4mm pen spring
1x - m3x20 screw for the trigger
8x - 10mm x 3mm round magnets
Instructions
Use out general instructions for cleanup, and smoothing tips.
https://www.3dcauldron.com/post/smoothing-3d-printed-items
Use the diagram images to see where the parts fit.
Glue the 8mm magnets in each hole.
Make sure that each magnet on the upper body is inserted so the polarity is the same for all 4.
The magnets on the lower body should also be oriented the same and oppsite those on the top.
Insert the 4mm pen spring in to the body.
Insert the trigger, and use the 20mm long screw to secure it.
The remainind parts are to be glued on.
